2023 Realistic 300-615 Dumps Exam Tips Test Pdf Exam Material
Powerful 300-615 PDF Dumps for 300-615 Questions
NEW QUESTION 34
Refer to the exhibit.
After the configuration is performed, guestshell continues to use 2%CPU. Which action resolves the issue?
- A. Resync the database
- B. Reboot the guestshell
- C. Recreate the guestshell
- D. Reboot the switch
Answer: B
NEW QUESTION 35
Refer to the exhibit.
The vPC between switch1 and switch2 does not work. Which two actions resolve the problem? (Choose two.)
- A. Configure one of the switches as primary for the vPC.
- B. Configure the IP address on the interface.
- C. Activate VLANs on the vPC.
- D. Correct the configuration of the vPC peer link and the vPC peer keepalive.
- E. Match the vPC domain ID between the two devices.
Answer: D,E
Explanation:
Explanation
Both "vPC peer link" and "Peer keepalive link" are down. So, D is correct.
SW1 is using vPC domain ID 500, which SW2 is using 20. They must match. So, E is correct.
NEW QUESTION 36 
Refer to the exhibit. A network engineer is troubleshooting a Cisco Nexus 5000 Series Switch. The interface between the server and the switch is nonoperational and is expected to operate at 10 Gbps. The drain rate of the interface is 3 Mbps. Which action resolves the issue?
- A. Set priority flow control pause
- B. Configure pause error-disable recovery
- C. Reset priority flow counters
- D. Enable link level pause on the interface
Answer: B
NEW QUESTION 37
Drag and drop the Cisco UCS SNMP fault types from the left onto the correct issues on the right.
Answer:
Explanation:
NEW QUESTION 38
Refer to the exhibit.
A client reports that the routing protocol neighborship fails to start between two Cisco Nexus switches, N9K-1 and N9K-2. Which action resolves the issue?
- A. Configure a unicast access list to allow the negotiation between N9K-1 and N9K-2
- B. Add OSPF routing configuration to interface e1/1 on both Cisco Nexus switches
- C. Add MTU configuration to interface e1/1 on both Cisco Nexus switches
- D. Configure a multicast access list to allow the negotiation between N9K-1 and N9K-2
Answer: A
NEW QUESTION 39
Refer to the exhibit.
A network engineer upgrades the firmware of a Cisco Fabric Interconnect from boot flash. During the process, the fabric interconnect reboots and displays the message shown in the exhibit. Which action resolves the issue?
- A. Boot the kickstart image from boot flash and load the system image
- B. Reload the switch and boot the kickstart image from the TFTP server
- C. Remove the service pack and upgrade through the auto-install procedure
- D. Reset the I/O module and install the firmware image from the boot flash
Answer: B
NEW QUESTION 40
An engineer discovers that an NPV/NPIV uplink experiences a heavy load and plans to add more uplinks.
Which statement about what occurs when the new uplinks are added is true?
- A. Only new connections use the new uplinks automatically.
- B. All connections must be reset before the new uplinks can be used.
- C. Paths must be defined before new connections can use the new uplinks.
- D. New and existing connections use the new uplinks automatically.
Answer: D
NEW QUESTION 41
Drag and drop the commands from the left onto the correct categories on the right.
Answer:
Explanation:
NEW QUESTION 42
Refer to the exhibit.
Refer to the exhibit. customer reports that all Intra-EPG isolation stopped working within a bare-metal tenant. Postman is running on a machine to get information from the APIC in case of orchestration failure. Which action resolves the issue?.
- A. Modify the GET command to reference the valid path for the managed object
- B. Match encap="vlan-10" and primaryEncap="vlan-110"
- C. Change pcEnfPref="unenforced" to pcEnfPref="enforced".
- D. Remove primaryEncap="vlan-110" from the specific port path.
Answer: D
NEW QUESTION 43
An engineer is troubleshooting issues in Cisco UCS Director. Drag and drop the possible causes from the left onto the correct issues on the right.
Answer:
Explanation:
NEW QUESTION 44
An engineer configures FCoE between a set of ESXi hosts and a Cisco Nexus 5000 Series Switch. The Converged Network Adapter of the host fails to receive the response from the Cisco Nexus device. Also, the VFC interface is in a down state and the FIP adapter fails to receive 802.1q tagged frames. The host interface is configured for VLAN trunking. Which action resolves the issue?
- A. Configure the UF link as a spanning-tree edge port
- B. Activate the reception of Xoff pause frames from the server
- C. Set the bound Ethernet trunk interface to non-FCoE native VLAN
- D. Enable the active STP port state on the bound Ethernet interface
Answer: C
NEW QUESTION 45
An engineer troubleshoots a custom AV pair that a client created on an external authentication server to map a read-only role for a specific security domain. Which AV pair solves the problem?
- A. shell:domains=Security_Domain_1//Read_Role_1|Read_Role_2
- B. shell=Security_Domain_1/Read_Role_1|Read_Role_2
- C. shell:domains=Security_Domain_1/Write_Role_1|Read_Role_2
- D. shell:domains=Security_Domain_1/Read_Role_1|Read_Role_2
Answer: A
Explanation:
Section: Management and Operations
NEW QUESTION 46 
Refer to the exhibit. An engineer must connect N2K-Fex-1 and N5K-Core-1 so that the traffic flow between the two devices uses load balancing. After inspecting the statistics of the interconnecting interfaces, the engineer concludes that only one link is used. Which action resolves the problem?
- A. Configure destination-mac load balancing on N5K-Core-1.
- B. Configure each uplink to be a member of a separate LACP port channel.
- C. Configure the pinning max-link as 2.
- D. Configure source-destination load balancing on N5K-Core-1.
Answer: C
Explanation:
Section: Network
NEW QUESTION 47
A mission-critical server is connected to site A. Connectivity to this server is lost from site B because the MAC route is missing in the OTV VDC of the Nexus 7000 in site B due to MAC aging. Which action allows the flooding of the unknown unicast MAC on the Nexus 7000 in the OTV VDC?
- A. Use the otv isis bfd <> command to configure BFD protocol.
- B. Use the otv flood mac <> command to selectively flood traffic for a given MAC.
- C. Use route-map to advertise this MAC statically and redistribute with ISIS.
- D. Unknown unicast flooding is not allowed.
Answer: B
NEW QUESTION 48
An engineer is troubleshooting issues in Cisco UCS Director. Drag and drop the possible causes from the left onto the correct issues on the right.
Answer:
Explanation:
NEW QUESTION 49
Refer to the exhibit.
The integration between Cisco UCS Manager and Cisco UCS Central failed. Which action resolves the issue?
- A. Implement the consistent NTP source between the appliances
- B. Implement the connectivity between the appliances through a firewall
- C. Configure the certificate between the appliances
- D. Configure the shared secret key between the appliances
Answer: A
NEW QUESTION 50
......
Preparation Options
No need to remind that the high-quality preparation resources are the guarantee of success in Cisco 300-615. Therefore, if you decide to take this exam, you need to study all the possible options for your comprehensive training. These are the two most helpful tools you can find:
- Troubleshooting Cisco Data Center Infrastructure v7.0
This official training course is vital for the candidates who choose 300-615 DCIT as their concentration exam for the CCNP Data Center certification. It contains the topics that focus on the data center infrastructure and teach troubleshooting of LAN, SAN, and Cisco Data Center Unified Fabric. In addition, this option emphasizes other Cisco technologies, including Cisco UCS and Cisco ACI. After the completion of the program, the individuals will be fluent in the methodologies that help identify various issues that occur in data center network architecture. More importantly, by the exam time, every applicant should also learn how to work with Cisco MDS, Cisco Nexus switches, and other Cisco network devices. All in all, it is a 5-day instructor-led course that also includes hands-on labs that will help you master your practical skills. The learners have the option to choose between virtual training, in-classroom sessions, or self-study eLearning. Nonetheless, before enrolling for this course, the interested individuals must be familiar with MAN and SAN on Cisco Nexus and MDS switches along with Cisco Unified Computing and Cisco ACI.
- How I Passed Troubleshooting Cisco Data Center Infrastructure (300-615 DCIT) Exam by Rocismo Liolentz Publications
This guide contains essential study tips, learning methodologies, and concepts that are claimed to help you be up in arms on the exam day. The authors managed to answer the most frequently asked questions regarding the exam structure, organizational issues, motivation and time management in preparation, as well as what domains are worth paying special attention to. It is available to anyone on the Amazon website.
Guaranteed Accomplishment with Newest Apr-2023 FREE: https://www.actualtestsit.com/Cisco/300-615-exam-prep-dumps.html
Authentic 300-615 Dumps - Free PDF Questions to Pass: https://drive.google.com/open?id=1aStMbq8GLOZw6VnPQGXhJ3ylEF_bLizc